© 2019 by Custom Skirting LLC. Use of Website and Purchase of Products Subject to Terms and Conditions

  • Facebook Clean

Install and Care Instructions!

 

Below is a video and some tips for taking off and installing your skirting.  More information to follow!

 

 

Your completed order will come with detailed Install and Removal Instructions

Quick Tips:

Tip 1

Usually it is best to install the skirt with a partner.  It works well to have one person feeding the skirt into the channel and the other person gently pulling it down the side.

 

Tip 2

When installing the skirt a little spray of liquid SILICONE (WD-40) along our channel system helps the skirt slide in smoothly. Be careful not to over spray as it will drip down the skirt.

 

Tip 3

For the vertical channel it is usually best to PUT the vertical in LAST (Install) and PULL the vertical FIRST (Removal)

 

Tip 4

All panels are labeled with the following system: The Circled number is the current panel and the number with the arrow is the next piece that attaches to that piece of Velcro. Example, This is Panel 2 and Panel 3 attaches at this side of the Velcro.  Panel 1 is always the front door on the passenger side.

To clean the skirt use warm water and a mild soap solution.  Allow to FULLY dry before storing.

 

If you are parked on a concrete pad or another location where you cannot install the spikes provided we recommend using a combination of 2x4’s and sand bags to hold the skirt down.  This is also recommended if you plan on moving during the winter, as the spikes will freeze to the ground.

 

For storing and transporting your skirt we recommend the following steps:

   -Stack like pieces of paper

   -Place the longest panel with the numbered side (the inside) faced down. 

   -Place the other panels with their numbers faced up

          (It will roll smoother if the welt is stacked as shown in this image)

   -Roll the skirt like a burrito and slide into the bag